Whirlpool, swim spa, pool pipe adhesive for bonding PVC pressure pipe systems.
CHF 13.90
Content:
125 Gramm
(CHF 0.11 / 1 Gramm)
Ordered by 5 p.m. today, delivered tomorrow
Product number:
E134
Manufacturer:
Henkel
Whirlpool, swim spa and pool pipe adhesive for bonding PVC pressure pipe systems.
- Offers maximum protection against leaks
- Reliably seals the gaps during bonding
INTENDED USE:
- For bonding thermoplastic PVC pressure pipe systems such as those installed in pools, whirlpools or swim spas
- Also suitable for unpressurized pipe systems such as pool drainage or suction
- Also suitable as a construction adhesive with PVC sheet material such as housing boxes or drip pans
PRODUCT ADVANTAGES:
- Very clean and easy handling
- Very good gap-bridging properties due to the low flow value, thus high protection against leaks
- Long open processing time of up to 3 minutes makes bonding easier
- For pipes up to max. 90 mm diameter
- Also very suitable for food applications, drinking water approved
- The adhesive joint is resistant to the water care products used in the pool area
INSTRUCTIONS FOR USE:
- Cut the PVC pipe at a right angle and then slightly chamfer and deburr the outside (15°).
- Pre-clean and dry the bonding surfaces.
- Mark the pipe penetration depth on the pipe ends.
- Apply Tangit cleaner to an absorbent paper towel to thoroughly clean the dry bonding surface.
- Apply adhesive to both adhesive parts and spread lengthwise with a brush (thin on the shaped part, thicker on the pipe end).
- Join the pipe and molded part without tilting or twisting within the open time (3 min.) and hold for a few seconds.
- Do not put any pressure on the bonded joint for at least 5 minutes.
- Waiting time before putting the pool into operation: 24 hours.
APPLICATION SAFETY INSTRUCTIONS:
- ALWAYS ventilate work areas well
- Avoid sparks and naked flames at all costs
- Always wear suitable protective clothing when working
- Please always observe the safety data sheet
Login
31 March 2024 21:39
-...
-